A pair of wire snips will cut tire stems right off, and quickly.
A can of expanding foam up the tailpipe into the muffler, and/or emptied into an engine compartment will ruin anyone’s day.
Submitted 1 day ago by WFloyd@lemmy.world [bot] to [deleted]
https://lemmy.world/pictrs/image/467a8776-441f-4c2b-bfcd-1c6850de356b.png
A pair of wire snips will cut tire stems right off, and quickly.
A can of expanding foam up the tailpipe into the muffler, and/or emptied into an engine compartment will ruin anyone’s day.
5 lug nuts can be loosened in about 5 seconds with a heavy duty impact wrench. If you’ve ever seen tires get stolen it only takes about 15 seconds to pull off.
That will be enough to disable the car. It’ll get moving before they notice it.
Make sure the battery is at full charge. Chevy typically uses 12mm or 14mm lug nuts in their trucks.
Used motor oil and sand in a water balloon also completely obstructs the view through any window and can’t be cleaned off.
I’m OOTL Please fill me in?
If the ICE vehicles don’t have wheels, they can’t move very fast…
ICE as in Internal Combustion Engine, or as in the US neo-brownshirts?
Battery powered impact driver plus a deep socket set = you can remove lug nuts or bolts (securing a wheel to a vehicle) in very quick fashion.
Don’t forget you can also ugga dugga them with an impact gun and cause the bolts to snap, so even if they get new lug nuts they aren’t going anywhere unless it’s up a flatbed
Also don’t forget your locking nut key for those pesky lock nuts
Also don’t forget your locking nut key for those pesky lock nuts
Leaving only those will make for a bigger surprise a few minutes later when they take a corner at speed. Or hit a bump.
If only one is locking just break the others. Locking will break in short order.
Just be careful because the pictured drill will break your wrist if you let it.
Know your tool before you use it.
Caltrops
Or, a small pair of pliers can open a brake bleed valve.
Fucking with the brakes risks getting bystanders involved, though.
Messing with the wheels can too if your plan isn’t leaving it sitting on cinder blocks. A runaway tire can do some damage at speed. Or if heaven forbid the vehicle rolls. Definitely wouldn’t want that to happen.
Slashing tires is faster and quieter.
Why use it on the vehicle and not the ICE agents? Rip their sacks right off with 2500 lbs of torque.
I Prefer Milwaukee, potayto potahto
PanaX@lemmy.world 1 day ago
one of these
ape_arms@lemmy.world 22 hours ago
How quickly can these remove the valve? could you cut off the stem with wirecutters faster?
thermal_shock@lemmy.world 21 hours ago
10 seconds or less. Leaves no damage or trace. I carry one in my glovebox.
SleeplessCityLights@programming.dev 10 hours ago
How does it go when you remove them from a fully pressurized tire? I have only ever removed cores when the tire was empty or had a low amount of pressure.
anomnom@sh.itjust.works 9 hours ago
Don’t fully unscrew it and you should be fine. Removing it completely makes a lot of noise, especially with higher pressure truck, uhaul and suv tires.
boonhet@sopuli.xyz 7 hours ago
Loosen somewhat, it’ll whizz out and they might be on the move before it runs flat. Then the tire is ruined.