VSO.

Image

So we got one of these rather silly sponge holder ducks.

Image

The only problem is that Mr. Quacks here doesn’t quite weigh enough. With a sponge his beak – especially one that’s laden with water – he’s prone to falling over into the sink. The sponge is held quite a ways outboard, and altogether the entire duck only weighs 65.4 grams.

I tried one other gimcrack solution before this, which was to glue a suction cup to his butt. That didn’t work very well.

Image

Instead, I opted to fill him up with some ballast. These will do nicely.

Yes, all of these pictures were just taken on my grubby stovetop. No, I am not going to pull out all the stops to perform my usual level of photography on, let’s not put too fine a point on it, a butt plug for a rubber duck.

I am also given to understand that I should have perhaps made such at thing corkscrew shaped, but I am very sorry to inform you that I didn’t do this, either.

Image

I didn’t count how many BB’s I used. Two fillings of that speed loader that came with my Crosman M4, is what it was. Now he weighs a much more suitable 265.7 grams, a little over four times the original weight, and acts rather like a weeble-wobble. With this you can tip him over so far the sponge falls out before he topples over himself. And can also shake him like a maraca, if you’re really bored.