Comment on T2 butter mold

aBundleOfFerrets@sh.itjust.works ⁨4⁩ ⁨weeks⁩ ago

• LastYearsIrritant@sopuli.xyz ⁨4⁩ ⁨weeks⁩ ago

  Just 3d print a mould and use it twice before you forget it exists.

  source

  • SARGE@startrek.website ⁨4⁩ ⁨weeks⁩ ago

    Please don’t use 3d printed parts in food preparation.

    You already have enough microplastics in your brains, and the layer lines are bacterial breeding grounds. (which are less of a concern if you only use it once or twice but is still relevant)

    Make sure you get a good coat of leaded paint to make sure none of that is a problem.

    source

    • AdrianTheFrog@lemmy.world ⁨4⁩ ⁨weeks⁩ ago

      Lead is actually a slight concern with new nozzles or abrasive filaments especially, as there’s usually a bit of lead in brass

      source
    • TachyonTele@piefed.social ⁨4⁩ ⁨weeks⁩ ago

      Lead paint chips: delicious but deadly!

      source

      • SARGE@startrek.website ⁨4⁩ ⁨weeks⁩ ago

        Sprinkle some on your pancakes, it’s quite sweet!

        source