it can make them more brittle (eapecially alongside prolonged time in the elements outside), but in a controlled environment like this it should be fine for a while :)
Comment on Indoor lettuce growing in 3D printed pots
hobbsc@lemmy.sdf.org 1 day ago
these look really cool!
I’m new to 3D printing so this might be a dumb question but does the water or moisture degrade the plastic? I’ve read a lot of posts about keeping your spools out of the humidity.
AmazingAwesomator@lemmy.world 1 day ago
frezik@lemmy.blahaj.zone 1 day ago
Depends on the filament type. Stuff like PLA and PETG have issues like that. ABS and ASA generally don’t. Outdoor stuff should generally be done in ABS or ASA (though I prefer to avoid them otherwise).
Natanox@discuss.tchncs.de 15 hours ago
Depends on the usecase though. If it’s something you could reasonably lose in nature (like markers you put in the ground, small signs and such) I’d rather use pure PHA. It will degrade of course, but that’s a good thing after all. I’d rather reprint some small utilities occasionally than damaging the very nature I’m trying to foster after all.