With this particular model, Prusaslicer is very optimistic about bridging and support generation:
- the right side (dark blue) has no support that could help with load-bearing
- the entire layer will be connected to those two lines
- more than 5cm long bridges
I don’t think this gcode will successfully print.
How do fix adjust the cura setting to generate a printable output?
The model in question is: www.delta-fan.com/Download/3D/BUB0612HJ-00.stp
stealth_cookies@lemmy.ca 8 months ago
Use support enforcers
EmilieEvans@lemmy.ml 8 months ago
Thanks. Is there also the option to rotate the pattern direction by 90° so it takes the short distances for bridges?
al177@lemmy.sdf.org 8 months ago
“fill angle” under infill settings.