Submitted 11 months ago by USSEthernet@startrek.website to 3dprinting@lemmy.world
https://startrek.website/pictrs/image/379f660e-8647-482d-962d-297fd5acf3c3.jpeg
Just finished installing it this evening. Going to update the firmware, run thermal model, and PID tune tomorrow. Also installed the silicone bed mod and need to level everything out. Got a busy day tomorrow, wish me luck.
Nice! I’ve had my revo nozzles for a few months now and really love the quick swap
Assuming my experience is everyones, you will like it. Don’t spend too much time on the thermal model, though. If you get it to work, great! If you don’t, there’s no shame in just turning it off.
Apparently the 3.13 fw supports the Revo now, so we’ll see.
I might just be a cheap bastard, but why not get a CoreXY for that price?
They make hotends with quick swap nozzles?
that’s a decent reason if you switch nozzles often. I leave a 0.6mm on my K1 Max permanently, best of both worlds
ericbomb@lemmy.world 11 months ago
May your highs be high and your lows short and with minimal frustration! Good luck!