Comment on Got my early Christmas present. I hope I like it.
4lan@lemmy.world 11 months agothat’s a decent reason if you switch nozzles often. I leave a 0.6mm on my K1 Max permanently, best of both worlds
Comment on Got my early Christmas present. I hope I like it.
4lan@lemmy.world 11 months agothat’s a decent reason if you switch nozzles often. I leave a 0.6mm on my K1 Max permanently, best of both worlds
USSEthernet@startrek.website 11 months ago
I had a .25 nozzle for small details but swapping is a pain in the ass with having to heat up to unscrew it. Then my heater block moves with it. Then you have to hope you don’t drop the hot nozzle on your bed and dent it (I know). I tend to print a variety of things so being able to quick swap will be nice.
yokonzo@lemmy.world 11 months ago
Or if you don’t screw it in JUST RIGHT It decides to become thinner than water and shoot out the sides 🥹
USSEthernet@startrek.website 11 months ago
I’ve never seen that (I tend to over tighten rather than under), but I can see how that can happen quite often.
yokonzo@lemmy.world 11 months ago
Its something really dumb like forgetting to heat up your hotend before you install it and it doesn’t make a seal or something