Well this stinks

Submitted ⁨⁨1⁩ ⁨week⁩ ago⁩ by ⁨the16bitgamer@programming.dev⁩ to ⁨3dprinting@lemmy.world⁩

Worst part, this is the one component Prusa injection molded with no parts 3D Printable. I’ll probably figure something out.

Comments

Sort:hotnew top

Kolanaki@pawb.social ⁨1⁩ ⁨week⁩ ago
Just print a ne- Oh… Yeah.

source
- the16bitgamer@programming.dev ⁨1⁩ ⁨week⁩ ago
  There are some community prints like this. printables.com/…/194982-prusa-minimini-no-logo-fr…
  
  But I don’t know how brave I feel about taking it apart again.
  
  source
Willem@kutsuya.dev ⁨1⁩ ⁨week⁩ ago
Send them a message? They are usually very helpful, you might be able to either get a model or a replacement part.

source
RealisticBroccoli@piefed.social ⁨1⁩ ⁨week⁩ ago
is it Abs? if so you could try welding it with acetone.

source
- the16bitgamer@programming.dev ⁨1⁩ ⁨week⁩ ago
  Just tried it, worked to hold it in position for a bit. Fell apart once I started to use it mechanically.
  
  source
yaroto98@lemmy.world ⁨1⁩ ⁨week⁩ ago
Superglue?

source
- the16bitgamer@programming.dev ⁨1⁩ ⁨week⁩ ago
  The plastic is brittle. I think I’ll just delay the inevitable if I use super glue
  
  source
DudeImMacGyver@kbin.earth ⁨1⁩ ⁨week⁩ ago
Contact them

source