RealisticBroccoli

@RealisticBroccoli@piefed.social

This is a remote user, information on this page may be incomplete. View original ↗

⁨Comment⁩ on ⁨Heated bed insulation⁩ ⁨⁨2⁩ ⁨days⁩ ago⁩:
I added an aerogel foam fromnaliexpress to my bed. So not sure how much aerogel is embeded in there. Could be it is just some glasfiber foam or something like that.

Temperaturen und er the BRD droped by at least 20C while printing Pla. Heating time droped slightly but my bed is pretty fast anyway. I couldn’t measure a noticeable drop in power consumption. But I measured it just like 15min each run.

This sheet was 15-20€ for 50x50x1cm

So I think the temp drop alone is worth it at least for me. And there should be a power consumption drop for longer prints.