Comment on Help Fixing my Dishwasher - Part 2
dudesss@piefed.ca 20 hours agoSo you’re saying this part could be broken? Is this the drain pump? Image
Could it helps this part instead? What is this part called? Also a drain pump?Image
Comment on Help Fixing my Dishwasher - Part 2
dudesss@piefed.ca 20 hours agoSo you’re saying this part could be broken? Is this the drain pump? Image
Could it helps this part instead? What is this part called? Also a drain pump?Image
AbidingOhmsLaw@lemmy.ml 20 hours ago
The top picture is the drain pump motor that would be the part that might need replacing if you are having a drain pump error coide. Before replacing it though I would check the windings (coils) to see it they are shorted ( 0 ohms) or burned (very high or infanate ohms). If it within range it might just be that it was not seated properly in the sump housing. The sump housing I’d the gray thing in the 2nd picture.
dudesss@piefed.ca 19 hours ago
I’m not sure where to apply my multimeter to test the coils
AbidingOhmsLaw@lemmy.ml 19 hours ago
Looks like there are 3 coils wired in a Y formation, so the silver rectangles are where they electrical contact is made, let’s call them 1,2, and 3. If you measure across any 2 points you should get the same ( or close) ohm reading. In this set up you are measuring across 2 of the coils so measuring 1 & 2 then 1 & 3 then 2 & 3 should all be simalar and should not read 0 or infinity.
dudesss@piefed.ca 19 hours ago
1 & 2, 1 & 3 do not read
2 & 3 reads