dudesss

These look great, thanks!

To a shower curtain? Let me know how it goes!

It was a broken drain pump. Thank you so much for your help!

This fixed the issue. Dishwasher is working great now. Thank you so much!

Take the battery out and run it only with the power cord

Thanks for all your help! I will try to replace the drain pump soon.

How can I repay you?

Could this have to do with the water to filling up anymore since I took the dishwasher apart to identify the drainage issue?

1 & 2, 1 & 3 do not read

2 & 3 reads

I’m not sure where to apply my multimeter to test the coils

The activate and clean lights are on which the guide indicates it could be a drain pump issue. Do you know if it could be both of the following and only 1? These are both “drain pumps”? They’re from my dishwasher.

Image

Image

So you’re saying this part could be broken? Is this the drain pump? Image

Could it helps this part instead? What is this part called? Also a drain pump?Image

The active and clean lights are flashing. So is normal washing. I’m guessing the drain pump is bad. And I don’t see anything visibly clogging it.

Oh thank you. I understand better now.

The active and clean light are flashing which the others person shared from their diagram that it could be to drain pump.

Bosch SilencePlus 50 DBA shx3ar75uc/28

Image

Image

To steps it says to use special function menu mentions button I do not have.

I tried asking AI, and it mentioned holding left arrow plus right arrow, then turning to changing on, and clean should flash multiple LEDs.

Delicate wash flashes and express wash stays lit when doing this. Then pressing start lights both those LEDs. Then press start again, I can hear something clicking twice, then the active and clean LEDs flash including delicate and express wash.

I’m not quiet sure how I would go about testing like that. And I never heard of working on a hot circuit.

I understand I could time the dishwasher and use that to help find what cycle it stops at.

These are the steps. It maybe stops somewhere between step 5.02 - 5.09 Image

Like the end with the white hose here?

Image

Water inlet valve here shows 990-995 Ohms

Image

Image

Tried that, thanks. Didn’t help the clog, but was nice to clean anyways. Haha.

Not yet. I still need to figure out where to find it and how to remove it.

I’m guessing I will need to open the dishwasher from the back?

I can hear water spraying inside yes.

Drain solenoid – I’m new to this stuff, how would I go about checking if it actuates a valve?

Thank you. I have moved the unit from the wall, and was able to blow the water from the tube into the drain. So I think its something to do with within the dishwasher itself.

Just responded. The tubes are fine. The filter, and as much as my hand can get into just after the filter.