Blown pump then if you can’t read anything on those pairs. They’re literally physical coils that should always pass current no matter what, and all of the smarts happens inside the control board for making the 215Hz @ 55V & 3A to feed it.
Comment on Help Fixing my Dishwasher - Part 2
dudesss@piefed.ca 1 month ago1 & 2, 1 & 3 do not read
2 & 3 reads
iocase@lemmy.zip 1 month ago
AbidingOhmsLaw@lemmy.ml 1 month ago
You have a dead coil you will have to replace the motor.
dudesss@piefed.ca 4 weeks ago
This fixed the issue. Dishwasher is working great now. Thank you so much!
AbidingOhmsLaw@lemmy.ml 4 weeks ago
Yure welcome, glade its working for you again :)
dudesss@piefed.ca 1 month ago
Could this have to do with the water to filling up anymore since I took the dishwasher apart to identify the drainage issue?
AbidingOhmsLaw@lemmy.ml 1 month ago
It’s possible that the controller is identifying an open coil and not filling, you should get an error code right away if so. it’s also likely that you did not get a connector seated correctly when re-assembling or that the float switch is stuck from having it tippled over. Check all the connections and after setting it back up right, check that that the float switch can move up and down freely.
dudesss@piefed.ca 1 month ago
Thanks for all your help! I will try to replace the drain pump soon.
How can I repay you?