Comment on I'm just gonna stick to slotted, thanks
helpImTrappedOnline@lemmy.world 4 months ago
Don’t discount hex, paired with a ball-end wrench, those are great for odd angles or tight spaces a straight wrench can’t get too.
Comment on I'm just gonna stick to slotted, thanks
helpImTrappedOnline@lemmy.world 4 months ago
Don’t discount hex, paired with a ball-end wrench, those are great for odd angles or tight spaces a straight wrench can’t get too.
KillingTimeItself@lemmy.dbzer0.com 4 months ago
they’re pretty good but semi liable to stripping due to lower surface area, as long as you use the right tool, and a quality one, you’ll be fine though.
Also hex is somewhat inter-compatible with torx, which is really cursed.
Aux@lemmy.world 4 months ago
Torx are easier to strip, especially the smaller sizes. They’re pretty much single use screws.
KillingTimeItself@lemmy.dbzer0.com 4 months ago
small screws in general are just easy to strip. Small torx is also liable to breaking a driver, like most small screws and drivers.
Torx though, i’ve never had strip out once, even doing construction with them. Phillips on the other hand, they kill screws constantly, and the bits themselves get all chewed up causing all kinds of problems. Torx bits still look fine though.
Torx aren’t exactly tapered, so they much less of a problem with stripping, compared to any tapered design, because tapered designs have issues with backing off.
Aux@lemmy.world 4 months ago
Hexes are very sturdy. I ride mountain bikes and for some reason brake rotors are secured with Torx while all other screws are hexes. Torx on rotors are usually tightened to 4-6Nm and they are single use 99% of the time. At the same time there are plenty of hexes of the same size which are tightened to 8-10Nm and there are zero issues.
Torx are fucking useless. And don’t get me started on tiny Torxes in laptops…