When a print is really stuck, I use a puddy knife with a fine edge and a hammer to get them separated.
Comment on Common printing questions
ArcaneSlime@lemmy.dbzer0.com 4 months agoI do! Lol I’ve had a print stuck to my bed for the last 2 weeks.
TonyOstrich@lemmy.world 4 months ago
brettvitaz@programming.dev 4 months ago
puffy knife
😮
ArcaneSlime@lemmy.dbzer0.com 4 months ago
I don’t want to scratch the glass or I would.
TonyOstrich@lemmy.world 4 months ago
This is a glass bed on an Ender that I am doing this on. I haven’t had any issues with scratching the bed whatsoever. Mild steel is actually softer than glass so it might actually be harder to scratch than you might think. Your mileage may vary though.
ArcaneSlime@lemmy.dbzer0.com 4 months ago
Huh, well, that’s what I’m on too so I guess maybe it’ll work out lol
Ahardyfellow@lemmynsfw.com 4 months ago
If it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it’ll pull off the glue.
ArcaneSlime@lemmy.dbzer0.com 4 months ago
It is, but muh freezer’s full of food and it is glue sticked lol.
Ahardyfellow@lemmynsfw.com 4 months ago
Damn that’s wild, what type of bed is it?
ArcaneSlime@lemmy.dbzer0.com 4 months ago
Ender 5 glass bed.