Comment on If it works, it works...
Your extruder might be set too low.
I’ll try turning it up, iirc I have been running like 220° for PLA+.
I meant your extruder’s z-offset it too low not the temperature.
Ahh I can try raising it, thanks!
ArcaneSlime@lemmy.dbzer0.com 1 year ago
I’ll try turning it up, iirc I have been running like 220° for PLA+.
CmdrShepard@lemmy.one 1 year ago
I meant your extruder’s z-offset it too low not the temperature.
ArcaneSlime@lemmy.dbzer0.com 1 year ago
Ahh I can try raising it, thanks!