Comment on If it works, it works...
ArcaneSlime@lemmy.dbzer0.com 1 year ago
I oddly usually have the other problem, my prints stick too good, the bottom of the print is white (though it is black PLA+) and it sometimes deforms my magnetic mat doohickey. Drives me crazy.
CmdrShepard@lemmy.one 11 months ago
Your extruder might be set too low.
ArcaneSlime@lemmy.dbzer0.com 11 months ago
I’ll try turning it up, iirc I have been running like 220° for PLA+.
CmdrShepard@lemmy.one 11 months ago
I meant your extruder’s z-offset it too low not the temperature.
ArcaneSlime@lemmy.dbzer0.com 11 months ago
Ahh I can try raising it, thanks!