Comment on Does Prusas textured sheet...work at all?
PetteriPano@lemmy.world 21 hours ago
Grease is bad for those PEI sheets. I wipe it off with alcohol before every print. They need to be hot, too. Around the glass transition temperature of your material. I exclusively print PETG. 70°C will fail, while 85°C will stick great.
captain_aggravated@sh.itjust.works 21 hours ago
Glue stick on glass. Got it. I’ll go to Lowe’s first thing in the morning to get some cut to size.
PetteriPano@lemmy.world 18 hours ago
I chipped so many glass beds back in the day with PLA and Elmer’s glue stick. I’d often put them in the freezer in hopes that they’d just release on their own. Alas, they chip there, too.
captain_aggravated@sh.itjust.works 17 hours ago
Witness if you will, the only two sheets of glass I’ve used since 2016:
Image
DaGeek247@fedia.io 20 hours ago
Tbh I've used hairspray and glass with no issue as well. It cheap after and easy to clean. ¯\_(ツ)_/¯
If you end up doing glass, check these babies out while you're at it; https://www.amazon.com/TBWHL-Prtiner-Picture-1inchx0-55Inch-26mmx14mm/dp/B08M9DH8Z4