Comment on Does Prusas textured sheet...work at all?
captain_aggravated@sh.itjust.works 20 hours agoI find the smooth one works adequately for PLA. I don’t have a satin one, and I think I’d have better luck printing on an inch deep tank of cod liver oil than the textured sheet.
I’ll go back to printing on glass and glue stick before I start fucking around with hair spray.
AngryishHumanoid@lemmynsfw.com 19 hours ago
I’ve tried all 3 and found hairspray the absolute winner of bed adhesion and it’s not even close.
captain_aggravated@sh.itjust.works 19 hours ago
I’ve printed PETG on glue stick on glass since Obama was president and until this week I would have told you PETG doesn’t peel the corners up like ABS does.
morbidcactus@lemmy.ca 10 hours ago
The only times I’ve had that happen was when the sheet wasn’t clean enough, bed temps too low or first layer being too close to the bed (though the textured sheet wants more squish)
The satin sheet is imo their best sheet, buildtak does some great surfaces in that size (pei sheet is great for even abs, their new surfaces are great too). I moved to using fr4/garolite sheets (I use this on my former mk3s, have a larger one for my voron too), not really found I needed adhesive for petg or pla on that.