Comment on Is this nozzle too low or bed temperature issue?
nieceandtows@programming.dev 1 week agoMakes sense, thanks for the picture. Is there a trick to the right friction when using the paper method?
Comment on Is this nozzle too low or bed temperature issue?
nieceandtows@programming.dev 1 week agoMakes sense, thanks for the picture. Is there a trick to the right friction when using the paper method?
fhein@lemmy.world 1 week ago
I think it’s more of an art form than an exact science to get perfect calibration using the paper method. It gives a decent starting point for further manual adjustment though. Personally I prefer to put a lamp behind the printer, and then babystep the nozzle down until I can no longer see any gap between it and the bed, but that also usually requires a few minor adjustments afterwards.