Comment on Is this nozzle too low or bed temperature issue?
fhein@lemmy.world 1 day agoLooks better, but IMO it looks like it’s still calibrated too close to the bed. In some places it looks like the material has been smushed into the surface, and in others it looks like ridges have formed between the lines where the nozzle has pushed excess material around. …prusa3d.com/…/First-Layer-Calibration-04.jpg
nieceandtows@programming.dev 1 day ago
Makes sense, thanks for the picture. Is there a trick to the right friction when using the paper method?
fhein@lemmy.world 15 hours ago
I think it’s more of an art form than an exact science to get perfect calibration using the paper method. It gives a decent starting point for further manual adjustment though. Personally I prefer to put a lamp behind the printer, and then babystep the nozzle down until I can no longer see any gap between it and the bed, but that also usually requires a few minor adjustments afterwards.