Comment on Is this nozzle too low or bed temperature issue?
ExcessShiv@lemmy.dbzer0.com 3 days agoLooks like you’re still way too close to the bed, I’d (numerically) increase Z-offset so you have more distance between the nozzle and the bed
Comment on Is this nozzle too low or bed temperature issue?
ExcessShiv@lemmy.dbzer0.com 3 days agoLooks like you’re still way too close to the bed, I’d (numerically) increase Z-offset so you have more distance between the nozzle and the bed
nieceandtows@programming.dev 3 days ago
Thanks for the feedback. I’m doing it by the paper method, so I might be guessing the right amount of friction wrong. Is there a trick to figuring out the right amount of friction using the paper?
ExcessShiv@lemmy.dbzer0.com 3 days ago
Just get it in the ballpark and microstep it during printing to fine tune and then save that value.