Comment on Is this nozzle too low or bed temperature issue?
ServantOfRa@lemmy.blahaj.zone 4 days ago
Looks to me that you could try raising the nozzle a fraction. Your extrusion looks flakey though, so it could be the nozzle as well. But on the other hand, if your nozzle is too close to the bed, that will inhibit extrusion as well.
nieceandtows@programming.dev 4 days ago
Yeah turns out the plate got bowed during shipping and was not exactly flat. After making it flatter and some cleaning, it’s looking a lot better. Image
ServantOfRa@lemmy.blahaj.zone 3 days ago
Those spring steel sheets are designed for magnetic beds that pull them flat so that makes sense. Happy printing!
ExcessShiv@lemmy.dbzer0.com 3 days ago
Looks like you’re still way too close to the bed, I’d (numerically) increase Z-offset so you have more distance between the nozzle and the bed
nieceandtows@programming.dev 3 days ago
Thanks for the feedback. I’m doing it by the paper method, so I might be guessing the right amount of friction wrong. Is there a trick to figuring out the right amount of friction using the paper?
ExcessShiv@lemmy.dbzer0.com 3 days ago
Just get it in the ballpark and microstep it during printing to fine tune and then save that value.
fhein@lemmy.world 3 days ago
Looks better, but IMO it looks like it’s still calibrated too close to the bed. In some places it looks like the material has been smushed into the surface, and in others it looks like ridges have formed between the lines where the nozzle has pushed excess material around. …prusa3d.com/…/First-Layer-Calibration-04.jpg
nieceandtows@programming.dev 3 days ago
Makes sense, thanks for the picture. Is there a trick to the right friction when using the paper method?
fhein@lemmy.world 2 days ago
I think it’s more of an art form than an exact science to get perfect calibration using the paper method. It gives a decent starting point for further manual adjustment though. Personally I prefer to put a lamp behind the printer, and then babystep the nozzle down until I can no longer see any gap between it and the bed, but that also usually requires a few minor adjustments afterwards.