No idea what they are trying to achieve outside of the “trying to kill this engine” part. I’m just hoping for the video of what goes wrong. (Hopefully not one of someone getting injured)
Comment on Supercharger pulley
SaveTheTuaHawk@lemmy.ca 2 months ago
There are reasons why they don’t make these out of plastic.
LifeInMultipleChoice@lemmy.world 2 months ago
TerraRoot@sh.itjust.works 2 months ago
I’ve a very small 2 lobe pump, it’ll pump extra air into the engine, make extra power and hopefully some nice noises.
Cheap engines make for fun toys, I’m surpized I haven’t kill it so far anyway.
empireOfLove2@lemmy.dbzer0.com 2 months ago
I’d run it for the prototype just for funsies until a shop can make the real part. It might last longer than you think.
TerraRoot@sh.itjust.works 2 months ago
If it was for something smooth like an alternator, i’d give it a try too, but this supercharger will take a fair bit of power to turn at 11000rpm and the pulses/vibration will kill PLA+, PA-CF I reckon would take the abuse easly, but the pulley faces would need smoothing or it would eat the belt.
TerraRoot@sh.itjust.works 2 months ago
It’s a test fit part, jlccnc will make the final piece out of 6061
Blue_Morpho@lemmy.world 5 weeks ago
Although I’d love to see what nylon cf could stand up to.
JigglySackles@lemmy.world 2 months ago
Oh thank fuck. Solid looking print though! This is fantastic use for 3d printing.