Comment on Bambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printers

empireOfLove2@lemmy.dbzer0.com ⁨1⁩ ⁨week⁩ ago

• teuto@lemmy.teuto.icu ⁨1⁩ ⁨week⁩ ago

  I blocked mine from the internet for good measure too.

  source
• Bronzie@sh.itjust.works ⁨1⁩ ⁨week⁩ ago

  I did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it.

  Any advice, as I’d like to go back to LAN Mode?

  Cheers

  source

  • Zeoic@lemmy.world ⁨1⁩ ⁨week⁩ ago

    I currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need

    source

    • Bronzie@sh.itjust.works ⁨1⁩ ⁨week⁩ ago

      Cheers, HA integration is on the plan for the future, I just strugle with time these days with a small kid and work.

      source
  • Bluewing@lemmy.world ⁨1⁩ ⁨week⁩ ago

    Roll back the firmware to a version that worked. You still can do that.

    source

    • Bronzie@sh.itjust.works ⁨1⁩ ⁨week⁩ ago

      I wish I could.
      Need to newer FW to use the drying function of the AMS2.

      I’m considering going back to LAN and just dealing with it though. I really prefer Orca over Studio

      source

      • bluewing@sh.itjust.works ⁨1⁩ ⁨week⁩ ago

        It would appear you are now trapped by Bambu into their product system.

        May God ha’ Mercy on your Soul.

        source