Print a calibration test. Orcaslicer has these built in. If Cura doesn’t, you can get them from Ellis’s excellent tuning guide.
Comment on Stumped - Improving fine detail prints with a .2mm nozzle?
surfrock66@lemmy.world 14 hours ago Yea, I’ve adjusted it down a bunch, but I think I bottomed out at 90%; do you think I should go lower?
IMALlama@lemmy.world 14 hours ago
StabbingSky@lemmy.zip 3 hours ago
Cura has plugins with the tests.
papalonian@lemmy.world 13 hours ago
I’ll second the other comment, Ellis’s guide is where I learned the trick above from. 90% sounds like it’s pretty low but I’ve had filaments and nozzles require as low as 83% for adequate results.