You can set the minimum extrusion width to a small value (20-25%) for better fill. You could also use classic mode with gap fill. You can use ironing for both to improve the results.
Comment on Is there a way to avoid those holes?
Eheran@lemmy.world 10 months ago2 replies pretty much in opposition to each other. So which one is correct? One says Arachne might be the cause, the other says to use that to fix the issue.
faebudo@infosec.pub 10 months ago
aBundleOfFerrets@sh.itjust.works 10 months ago
Arachne is more cleverer but more susceptible to poorly tuned settings (than the classic slicing engine)