Comment on Is there a way to avoid those holes?
faebudo@infosec.pub 2 months ago
Does your slicer have Arachne slicing mode? It will use variable extrusion width which will help to prevent most of those gaps.
Comment on Is there a way to avoid those holes?
faebudo@infosec.pub 2 months ago
Does your slicer have Arachne slicing mode? It will use variable extrusion width which will help to prevent most of those gaps.
Eheran@lemmy.world 2 months ago
2 replies pretty much in opposition to each other. So which one is correct? One says Arachne might be the cause, the other says to use that to fix the issue.
aBundleOfFerrets@sh.itjust.works 1 month ago
Arachne is more cleverer but more susceptible to poorly tuned settings (than the classic slicing engine)
faebudo@infosec.pub 2 months ago
You can set the minimum extrusion width to a small value (20-25%) for better fill. You could also use classic mode with gap fill. You can use ironing for both to improve the results.