Comment on cannot get an even first layer with a voron trident
muusemuuse@lemm.ee 1 month agoI looked at your guide and theres something interesting mentioned for my model, the trident. the actual temp is lower that the measured temp on the top of the bed due to the thickness of the bed! I shoudl raise it by 10 degrees. I’m going to try that in a bit
morbidcactus@lemmy.ca 1 month ago
Yeah, makes sense based on where the sensor is, my heater didn’t have a thermocouple on it so I drilled a hole for a thermistor midplate, it’s super slow to respond is the downside but in theory it should be accurate enough.
I don’t have experience with the bambu, in theory everything will experience thermal expansion but for the voron setup, the bimetallic construction is some of the issue, they have different thermal expansion properties so it can cause deflections.