Comment on Motherboard swap!
SpaceNoodle@lemmy.world 4 months ago
Make sure to rinse the new one off on the sink before you pop it in!
Comment on Motherboard swap!
SpaceNoodle@lemmy.world 4 months ago
Make sure to rinse the new one off on the sink before you pop it in!
Koopa_Khan@lemmy.world 4 months ago
Instructions unclear, I’ve given the whole printer a bath and now all it does is blow bubbles
SpaceNoodle@lemmy.world 4 months ago
I actually worked at a facility where we really did thoroughly clean (inkjet) printers since the customer returns would get NASTY.
Some of the electronics, like those on the printer head, are actually fine with a good rinsing as long as you then thoroughly dry them off with the air hose.
This surely does not transfer to modern 3D printers.
Koopa_Khan@lemmy.world 4 months ago
Now i’m curious. Was it just a lot of dust and dried Inc. or what else was in them?
SpaceNoodle@lemmy.world 4 months ago
The difference was that these printers were installed in bakeries, and were printing edible ink onto edible paper. If the owners didn’t keep up on basic maintenance or general cleanliness, there could be a fair amount of mold, or - far more often than you’d hope - lots of roaches.