antianarchist

This.

Just create a 50x50x0.2 “cube”. Then let it print 3-4 lines. If the filament is round like spaghetti and not touching each other, you are too high. Lower it. Repeat until the filament is so much pressed down, that it flows to the sides (you can see ridges next to where the nozzle printed). Then you are too low. Ideally, you just have a very flat, connected surface.

As soon as you change the temperature of the extruder or heatbed, you might have to calibrate the z-axis again. Other than that, it doesn’t have to be perfect.

980 Pro? Rich kid…

I can get that and I also prefer sticking to major versions. However, I am chaotic and easily have 50 different docker images, checking all the release cycle of all of those gets exhausting.

I believe I need to start generating notifications if a tag has not received an update for more than 30d.

I hate providers not offering me a latest tag. Is there any valid reason not to do that?

Even worse, super stupid version tags such as MinIO is using: RELEASE.2025-09-07T16-13-09Z-cpuv1 (I wish I made that up)

@talkingpumpkin@lemmy.world you have the genes of IE6