mortalic

Never used alpaca. So I can’t help there.

Probably setup ollama with qwen and aider first. Then give it the docs for the things you want to set up.

Sorry I should have thought to lead with that. It’s a prusa xl, in an old creality enclosure. It isn’t heated but stays pretty consistent. This is eryone pla

Being honest, I’d printed this 5 or 6 times before with the default supports. Most of the time it was fine but the last two times it was falling over and basically making a messy bridge. So I tried organic supports, which is what we see here.

That does seem to be a good suggestion. I think I’ll do that.

I took the default prusa slicer snug setting. Though I will check tomorrow to see what else might be set. I remember when reading up on organic supports that there were some suggested changes to support settings. Maybe I changed something… I don’t think so though.

Maybe, this is in an enclosure though, so that seems fairly unlikely

That’s a good idea, maybe I’ll go e that a go tomorrow

Rimworld, around 3590 All the civs… Several thousand