So I’ve been noticing a few of my recent prints had some under extrusion around the z seam leaving indents that look like tearing. After basic troubleshooting I come to find that the issue is in the slicer. Could somone help me figure out what settings I need to change? Changing the z seam type doesn’t really help, it just seems like cura is refusing to close the seam and would rather my prints have a fissor on them.
Check your “coasting” settings - if it’s turned on, try turning it off or reducing the value since it can cause exactly those fisures at the z-seam when set too aggressively.
deepfriedchril@lemmy.world 3 weeks ago
Preasure advance too high?
AliasVortex@lemmy.world 3 weeks ago
That or a
wall wipe distance
maybe? It’s been ages since I’ve used cura though…