I’ve begun printing more minis for TTRPG, and since i only have a cheap bedslinger that’s what I’m using.
Normally I’ve just stuck with minis designed specifically for supportless FDM printing, but I wanted to try my hand at something else and went with this Minotaur
fresh from the printer, supports all over
There’s still a lot of post-processing before priming and painting, but I’m actually pretty happy with the quality, considering it was done on a $200 entry-level printer.
Printed in eSun PLA+ with a 0.2mm nozzle and 0.08mm layer height, it took just short of 9h to print it.
voracitude@lemmy.world 1 day ago
I’m surprised by the quality of the print, I’d love to see other pieces you’re proud of (and some you weren’t so happy with, too)!
ExcessShiv@lemmy.dbzer0.com 1 day ago
goblin with sword and shield
skeleton with halberd
orc with bow
I’m pretty happy with the goblin and skeleton, the orc’s bow is a little wonky at the top because my layer time was too short for my printers cooling. None of these has had any post processing done yet, printed without any supports also 0.2mm nozzle and 0.08mm layer height.
I think I’ll try printing a sort of “buffer tower” next time to increase layer time on prints with pointy tips and see if it helps.
voracitude@lemmy.world 1 day ago
Damn, dude. I’ve been thinking about getting a 3D printer and was leaning towards resin because I heard it was better for minis, and I see how it’s different, but these look perfectly fine and there’s no fumes or toxic sludge to deal with. Since I mainly want it for printing household fixits and ease-of-use is a factor, being able to get back into tabletop gaming (and painting) as well is a very nice bonus. I feel pretty good about going with an FDM printer now!
paf@jlai.lu 1 day ago
I have 3 printers and first was the OG ender 3 pro with only couple of mods (mainboard and cooling duct/fan), while it is slower and needs more manual calibration, I get same print quality than bambulab A1. It is actually even better on overhang parts
ExcessShiv@lemmy.dbzer0.com 1 day ago
I have switched out the fan duct and heat block (to use normal volcano) on mine as the only HW changes, and then I’ve flashed the main board with klipper. Using klipper has been a crazy step up in printing quality over the stock firmware because it gave me the control needed to do a proper tuning of my printer.