Y, just use a little file and gently rub it over the two places you're going to be connecting. Then use some E6000 and a clamp. I can't remember why this is, but I do know that glue tends to stick best when spaced out. Perhaps the roughing up of the area permits for micro-gaps which allow for the two to better stick? Or that smooth faces in general do not stick well to one another. But I do know whenever gluing plastic I just grab a little metal file and always rub it over whatever part I will be hiding with glue.
Comment on What is the recommended way to bond a resin-printed part to a PLA part?
empireOfLove2@lemmy.dbzer0.com 6 months ago
Make sure to rough up the resin surface to be glued then use CA glue and send it. I’m sure it will be sufficient.
cashmaggot@piefed.social 6 months ago
nous@programming.dev 6 months ago
Perhaps the roughing up of the area permits for micro-gaps which allow for the two to better stick?
I think it is more to do with increased surface area - more molecules of the glue are in contact with the part.
cashmaggot@piefed.social 6 months ago
Seems so strange in my head, that you're removing body yet the surface area is increased? But I actually truly don't know the science (and actually did not look it up because it's pretty irrelevant to me). But I do like to look stuff up. I think I just fell down the pie-hole and didn't take the time. Maybe it's like a razor, where as you sharpen it and the surface area changes the quality of the shave?
Eh, now I really do have to look into it. Cause clearly you're saying what it is - I just gotta figure out how you subtract material and it increases surface area. To the internet~
nous@programming.dev 6 months ago
I just gotta figure out how you subtract material and it increases surface area.
Say you have a smooth shape like: ███ That has a nice and simple area and surface area. But if you take a chunk out of it: █▂█ you now have less area, but surface area is the same plus those two new vertical walls - so it has increased. That is basically what roughing up the surface does. Might also do some deformation and add some peaks as well though far less than the material removed.
This all leads into the coastline paradox and fractal patterns which show that you can have a finite volume surrounded by an infinite surface area. Here are some interesting videos on the topic: www.youtube.com/watch?v=AD4vPNBSrKY www.youtube.com/watch?v=I_rw-AJqpCM www.youtube.com/watch?v=gB9n2gHsHN4 www.youtube.com/watch?v=3s7h2MHQtxc
FuglyDuck@lemmy.world 6 months ago
Rough up both surfaces.
Alternatively, if you want a removable bind, barges. It can be neater (barges is weird. You paint it on both parts after a few minutes, it’ll be not-tacky, but’ll bond to other barges. You can remove it with the application of gentle heat. It’s also flexible.)
Finally VHB tape from 3m is wonderful,