Comment on I'm just gonna stick to slotted, thanks
Aux@lemmy.world 4 months agoTorx are easier to strip, especially the smaller sizes. They’re pretty much single use screws.
Comment on I'm just gonna stick to slotted, thanks
Aux@lemmy.world 4 months agoTorx are easier to strip, especially the smaller sizes. They’re pretty much single use screws.
KillingTimeItself@lemmy.dbzer0.com 4 months ago
small screws in general are just easy to strip. Small torx is also liable to breaking a driver, like most small screws and drivers.
Torx though, i’ve never had strip out once, even doing construction with them. Phillips on the other hand, they kill screws constantly, and the bits themselves get all chewed up causing all kinds of problems. Torx bits still look fine though.
Torx aren’t exactly tapered, so they much less of a problem with stripping, compared to any tapered design, because tapered designs have issues with backing off.
Aux@lemmy.world 4 months ago
Hexes are very sturdy. I ride mountain bikes and for some reason brake rotors are secured with Torx while all other screws are hexes. Torx on rotors are usually tightened to 4-6Nm and they are single use 99% of the time. At the same time there are plenty of hexes of the same size which are tightened to 8-10Nm and there are zero issues.
Torx are fucking useless. And don’t get me started on tiny Torxes in laptops…
KillingTimeItself@lemmy.dbzer0.com 4 months ago
you’re not using like, soft fasteners or some shit right?
I could see hex performing better on a softer material. That or you’re doing something goofy. I’d be surprised if torx were stripping at that low of a torque rating, unless ur using hex drivers on them or something.
Aux@lemmy.world 4 months ago
Fasteners are standard from rotor manufacturers. I have no clue what they’re made out of. But in 30 years of cycling I’ve never had a single Torx which would last more than one cycle of screw in screw out.