I’m just going to assume bolts of lightning and Usain Bolt are off the table.
The only thing I know about the procedure for tightening Usain Bolt is that I am not part of performing it.
Comment on Automation
riskable@programming.dev 4 months agoTo be fair, that’s a very open ended question. I mean, what kind of bolt are we talking about? A standard lag bolt? If so you don’t tighten it! That’d be a trick question! You tighten the nut. Same thing applies with car wheel bolts. Tricky tricky!
Is it a hex bolt that also has a cross head? How tight are we talking?
I’m just going to assume bolts of lightning and Usain Bolt are of the table.
Schadrach@lemmy.sdf.org 4 months ago
Bertuccio@lemmy.world 4 months ago
I did actually make the mistake of asking just “which way do you turn a screw” once and the person had the sense to ask “to tighten or loosen it?”
Malfeasant@lemmy.world 4 months ago
Would you have accepted “righty tighty lefty loosely”?
Bertuccio@lemmy.world 4 months ago
Yeah but if they don’t show which is which I ask them to show too.
Almost everyone gets screw turning right, it just weeds out a few people who say the right things in emails.
Aceticon@lemmy.world 4 months ago
Not really in a bolt tightenning domain, but I have done technical interviews for a lot of devs including junior ones, and them asking all those questions about the task is something I would consider a very good thing.
At least in my domain the first step of doing a good job is figuring out exactly what needs to be done and in what conditions, so somebody who claims to have some experience who in when faced with a somewhat open ended question just jumps into the how without first trying to figure out the what is actually a bad sign (or they might just be nervous, so this by itself is not an absolute pass or fail thing).