Comment on Awwwww for cryin' out loud!!!!
Grass@sh.itjust.works 4 days ago
I sort of did this today. I was testing what each setting in orca slicer’s scarf seam section did and I had the scarf flow at 0.6 and forgot I even had scarf seam on but some seemingly random features ended up as disconnected lines and I blew through like half a roll in calibration prints that came out flawless or near flawless before I realized
Bluewing@lemmy.world 4 days ago
Try setting the scarf steps to 1 and the Bridge Flow ratio to 1.5, (as low a 0 and as high as 2). Then under Speed uncheck the Slow Down for Overhangs and set the speed to 20mm/sec. This is often a good place to start and works well on my Bambu mini. For testing, I print an upside down box with a 50x50 cavity and a height of 8mm.