It’s printed out of ASA, which basically doesn’t creap. It’s also wayyyy overbuilt for the amount of weight it’s supporting. I’m not at all worried about it failing over time.
Comment on Very Specific Object: Made a wall mount for my NAS and its UPS
DABDA@lemmy.world 10 months ago
What kind of filament is that printed with and are you concerned about it failing over time? Especially if there’s spinning disks in there I’d be paranoid as hell about it falling.
IMALlama@lemmy.world 10 months ago
einlander@lemmy.world 10 months ago
As long as it’s not pla. That’s a ticking time bomb.
IMALlama@lemmy.world 10 months ago
It’s ASA, should be more than fine :)
owen@lemmy.ca 10 months ago
I think it looks fine, the layers are aligned appropriately and it seems at least 5mm thick
Jayb151@lemmy.world 10 months ago
I disagree. It seems that the letters are along where the stress is, which can eventually cause determination. This part scares me when you consider how important what it’s holding it’s.
threelonmusketeers@sh.itjust.works 10 months ago
letters
layers
determination
delamination?
it’s
is
KickMeElmo@sopuli.xyz 10 months ago
He said in another spot that it’s ASA.
charles@lemmy.world 10 months ago
This scares the hell out of me. Too much risk of damage. Heat, weight, and time.
IMALlama@lemmy.world 10 months ago
There’s basically no heat involved. It sounds like you’re worried about creap, which is totally fair and something to be aware of. The parts are printed out of ASA and are very overbuilt, so there shouldn’t be any cause for concern.
Creap video: youtu.be/88pk2cNOeGE?si=_JxBtYyYitBEin2Y
rambos@lemm.ee 10 months ago
It looks beefy enough to me
SzethFriendOfNimi@lemmy.world 10 months ago
I’d print it but using ABS
IMALlama@lemmy.world 10 months ago
It’s ASA, it’ll be fine :)
SzethFriendOfNimi@lemmy.world 10 months ago
Yeah. That’ll be good.
Vytle@lemmy.world 10 months ago
This man has never heard of 3d2a :P