Comment on Stuttering when printing PETG
TwanHE@lemmy.world 9 months agoThinking about this again, could it be you have something like “wait for layer time” on and a very high minimum layer time set for your petg profile?
Comment on Stuttering when printing PETG
TwanHE@lemmy.world 9 months agoThinking about this again, could it be you have something like “wait for layer time” on and a very high minimum layer time set for your petg profile?
DreadPotato@sopuli.xyz 9 months ago
I was overloading the controller with gcode commands due to high gcode resolution. I increased from the profile default 0.0125mm to 0.5mm and it went away. I’m going to see how fine I can set the resolution without introducing the stutter, but at 0.5mm it still looks good.