If its stopping 10 to 20 seconds there’s definitely something in the gcode making the printer hang. I’d try slicing the file again with a different slicer to be sure.
Comment on Stuttering when printing PETG
DreadPotato@sopuli.xyz 9 months agoIt’s not small blobs like here, it’s huge blobs because the printhead doesn’t move for 10-20 seconds, so filament from the chamber keeps oozing while it just sits there.
TwanHE@lemmy.world 9 months ago
TwanHE@lemmy.world 9 months ago
Thinking about this again, could it be you have something like “wait for layer time” on and a very high minimum layer time set for your petg profile?
DreadPotato@sopuli.xyz 9 months ago
I was overloading the controller with gcode commands due to high gcode resolution. I increased from the profile default 0.0125mm to 0.5mm and it went away. I’m going to see how fine I can set the resolution without introducing the stutter, but at 0.5mm it still looks good.