BL touch works great but you need to get the Z offset. Then you can just G29 before the print or whenever and it works great. I hate manual levelling and these days there isn’t much reason for it. I’ve just upgraded to a Bambu P1S and levelling is even more straightforward since there is no Z-offset since it uses the hotend itself to probe.
Comment on Upgraded Ender 3v2 Issues
Fiivemacs@lemmy.ca 10 months ago
Tbh, I threw the bl touch in the garbage and just eyeball my levelling. It’s never failed me on any print. Takes more time and patience but I know it’s done right.
arc@lemm.ee 10 months ago
xzot746@sh.itjust.works 10 months ago
I’ll try running sans BL Touch, it’s just weird that it was working before the board change without issue. I’ve cranked down on the silicon spacers to make sure it’s difficult for them to loosen up over time, will see how that goes.
Thanks for your comment.
damium@programming.dev 10 months ago
You might also try running a few leveling probes in a row to check the repeatability of the measurements. It’s possible that something is messing with the ability to make good measurements (unstable power feed, heat warp, probe binding, etc).
xzot746@sh.itjust.works 10 months ago
I’ll give that a go. Thanks for the idea.
rug_burn@sh.itjust.works 10 months ago
Would seem odd, but if it seems like your leveling wheels are backing off, maybe the threads are worn on them? It would suck to replace them only to find out that wasn’t the issue though, but if you have a spare set / originals if you’ve upgraded, maybe see if those are more stable?