Comment on Iowa Demolishes Its First 3D Printed House
Kbin_space_program@kbin.social 11 months agoBecause you can't as easily slap the word "luxury" in front of "mobile home" and have it be believable.
Comment on Iowa Demolishes Its First 3D Printed House
Kbin_space_program@kbin.social 11 months agoBecause you can't as easily slap the word "luxury" in front of "mobile home" and have it be believable.
SkepticalButOpenMinded@lemmy.ca 11 months ago
Pre-fabricated homes are not all mobile homes. I wrote this elsewhere, but a lot of those charming 100 year old homes on the east coast and midwest are pre-fabricated Sears catalog homes.
captain_aggravated@sh.itjust.works 11 months ago
Is it correct to call those Sears houses “pre-fabricated?” The lumber was sawn to size if I understand right, but it still had to be stick-built on site. It’s not like it was built in pieces in a factory, trucked to the site and assembled.
SkepticalButOpenMinded@lemmy.ca 11 months ago
Are IKEA dressers pre-fabricated? I would say that having plans, everything cut to size, and all the hardest parts done for you counts for a lot.
For Sears catalog homes, everything in the kit was measured, cut, numbered, and packaged in a factory, including electrical and heating, and the kits were advertised as easy and fast to build for people with no expert skills. Pre-fabrication is a spectrum, and all pre-fabs require some degree of construction on site.
captain_aggravated@sh.itjust.works 11 months ago
No, IKEA dressers are categorically not pre-fabricated. Basis for my assertion: IKEA and other flat packed furniture arrives in a “some assembly required” state, compared to “normal” furniture which arrives from the factory fully assembled and ready to use. Nuts like me that have their own personal wood shop and build their own furniture from scratch are the exception, rather than the norm.
In the aviation world, there’s a category for Experimental - Amateur Built aircraft. There is a rule for certifying an aircraft in this category: The amateur builder must perform 51% of the fabrication and assembly of the aircraft. There’s this whole points system for figuring that up as well. There are kit manufacturers, but they can’t offer “We cut all the material to their final size, drilled all the holes etc. so all you have to do is rivet and bolt it together” because there’s no way to make that total up to 51%. They can give you enough sheet stock cut to rough size for you to fabricate wing and fuselage panels out of, provide an engine, etc. These airplanes are often informally referred to as “kit-built.”
I think “kit-built” lives somewhere between “from scratch” and “pre-fabricated.”