Comment on It took over 2 years, but I finally finished my partially 3D Printable E-Reader Case
the16bitgamer@lemmy.world 11 months agoIf it’s a 7.8” I have a standard base for it too. Just need to do a bit of clean up on it first though. Though I’ve yet to make one for bigger since my print bed is only 200mmx200mm
phx@lemmy.ca 11 months ago
Yeah mine is 7.8" so if you happen to publish that base it should fit. Thanks!
the16bitgamer@lemmy.world 11 months ago
Here is the base frame for our 7.8" E-Reader case github.com/the16bitgamer/…/7.8 inch
If you need an example on how to make the arms the 6" is probably the better place to go, as it’s going to take a bit to clean up the cases.