Comment on Extruder clicking
mystik@lemmy.world 11 months ago
Could be too much pressure – double check your z-offset/leveling? I had it so bad, and didn’t realize it, … and wore out the original brass gear :(. The nozzle was pushed right up against the bed, so it was trying so hard to push out filament that wasn’t going anywhere.
Koopa_Khan@lemmy.world 11 months ago
I just test, unfortunately it looks like thats not the issue. But that raises the question, could the spring tension be to high?
MissJinx@lemmy.world 11 months ago
in my case it was too cold. My HE doesn’t work very well and every time this happens is because it’s not heating enough