Comment on Did Bambu Lab change something on the A1 recently?
paf@jlai.lu 4 weeks agoBe careful if you seal it completely, electronics won’t be able to cool down properly, it needs some fresh air.
Comment on Did Bambu Lab change something on the A1 recently?
paf@jlai.lu 4 weeks agoBe careful if you seal it completely, electronics won’t be able to cool down properly, it needs some fresh air.
GreenKnight23@lemmy.world 4 weeks ago
thanks for the input. I’m going to be moving the controller outside the enclosure but there’s still the motors and hot end to contend with.
I suppose I could monitor interior temps and activate the venting/filter when it reaches temp. would be tricky though, because then I would risk feeding a fire and allowing it to escape should one start.
paf@jlai.lu 4 weeks ago
Mainboard and psu are the ones to take care the most but keep in mind that not all filament like to be printed in fully closed enclosure (without proper ventilation), PLA for exemple.
One way to monitor and secure my printer is to use smart devices. I have home assistant running at home, my printer has an integration available and i can recover several printer informations like status, temps, printing time… and i have several smart devices (mostly zigbee) which i use to monitor and apply automation based on scenarios. (temperature sensor, smoke detector, camera, light, plug to power on/off printer). I can then create automation like “when smoke detector has detected smoke, turn off printer, then send picture to my phone and broadcast a message in the house…”. I have maybe 5 different automation running for the printer but the possibilities are endless.