Comment on Anyone who's used the Anycubic Kobra Pro, what is your experience?

• JackGreenEarth@lemm.ee ⁨1⁩ ⁨year⁩ ago

  Uk. The firmware suddenly resolved itself, but now the y axis (the bed) doesn’t seem to be moving properly, it tries to move off where it can’t, and says ‘out of range’ to moving where it can.

  source

  • kek_w_lol@lemmy.one ⁨1⁩ ⁨year⁩ ago

    Just in case, check the PSU Voltage. Check the plugs on the Y axis motor. Worst case, you might need to redownload the CFG file for your printer. Try that. Write again if none of that works.

    source

    • JackGreenEarth@lemm.ee ⁨1⁩ ⁨year⁩ ago

      Thanks for outlining the steps, but I’m not sure what each thing you recommended entails. Are you able to explain it in more detail please?

      source