Comment on Anyone who's used the Anycubic Kobra Pro, what is your experience?
JackGreenEarth@lemm.ee 1 year agoThe SV07 (just now) the firmware almost immediately broke after I put it together, powered it on, started it autoleveleling and the stopped it because it was screeching, and the rebooted it. Now it won’t power on without showing green text, or doesn’t progress past the loading screen, or doesn’t turn on at all. It’s different every time.
kek_w_lol@lemmy.one 1 year ago
What country are you located in?
JackGreenEarth@lemm.ee 1 year ago
Uk. The firmware suddenly resolved itself, but now the y axis (the bed) doesn’t seem to be moving properly, it tries to move off where it can’t, and says ‘out of range’ to moving where it can.
kek_w_lol@lemmy.one 1 year ago
Just in case, check the PSU Voltage. Check the plugs on the Y axis motor. Worst case, you might need to redownload the CFG file for your printer. Try that. Write again if none of that works.
JackGreenEarth@lemm.ee 1 year ago
Thanks for outlining the steps, but I’m not sure what each thing you recommended entails. Are you able to explain it in more detail please?