Comment - FBXL Lotide

sbeak@sopuli.xyz ⁨1⁩ ⁨week⁩ ago

First layer test print worked fine for me, quite smooth aside from a few bumpy bits. This is a 60x60cm square I found on Printables.

There are minor bumps near the middle, are those of any concern? This is immediately after I used the automatic bed levelling function

Sort:hotnew top

Blue_Morpho@lemmy.world ⁨1⁩ ⁨week⁩ ago
It could be the lighting but when I do a layer 1 test print it looks like a sheet of paper without the large ridges like on your print. Does your sheet hold together like a sheet of paper or is it stringy?

source
- sbeak@sopuli.xyz ⁨1⁩ ⁨week⁩ ago
  It does feel like a sheet and isn’t stringy
  
  source
ExcessShiv@lemmy.dbzer0.com ⁨1⁩ ⁨week⁩ ago
It’s a little hard to see due to low resolution, but it looks like you have small gaps between infill lines. If that’s the case you need to reduce Z-offset to get more squish.

source
sbeak@sopuli.xyz ⁨1⁩ ⁨week⁩ ago
The bent bit in the corner was from me trying to peel it off the build plate, ignore that

source