Comment on How to properly get rid of holes between perimeters?

• Natanox@discuss.tchncs.de ⁨1⁩ ⁨day⁩ ago

  It’s not just in corners.

  source

  • MrTolkinghoen@lemmy.zip ⁨1⁩ ⁨day⁩ ago

    PA can impact more than just corners. It’s when the print head is changing speed/direction

    source

    • Natanox@discuss.tchncs.de ⁨21⁩ ⁨hours⁩ ago

      The issue is also present on long straight lines though.

      source

      • MrTolkinghoen@lemmy.zip ⁨12⁩ ⁨hours⁩ ago

        Calibration of a printer is very much a cumulitive thing. Looking at your print I think your PA is off, but I would guess that it’s a combination of multiple settings. When calibrating a filament, I usually do a sweep of calibrations, and then sometimes even come back to past steps to rerun since the values can impact eachother.

        I.e. I typically do in this order per brand of filament type. Always starting with the closest preset I can find. Usually the generic version if there isn’t the brands of exact filament as a preset in orca.

        Temperatue

        Max volumetric speed

        Pressure advance

        Flow

        Retraction

        Sometimes back to PA because flow can impact PA

        VFA/input shaping (optional)

        And then toss a tolerance calibration at it at the end, but I don’t typically do this per filament, just do it per printer unless you’re about to print some super tolerance intolerant parts

        source