Comment on How to properly get rid of holes between perimeters?
faebudo@infosec.pub 1 month ago
If it’s in corners only tune Pressure Advance, but as this is on the first layer it’s probably only the first layer, which is generally different from subsequent layers. Check the same thing on a higher layer to make sure that there really is a problem.
Natanox@discuss.tchncs.de 1 month ago
It’s not only on the first layer and also not only around corners (indeed the first layer is perfectly fine). The perspective is a little bit misleading, this is the third or fourth layer. Happens on all layers, it’s just a little bit more common around corners and bends.
MrTolkinghoen@lemmy.zip 1 month ago
This comment is correct imo. Read / calibrate the pressure advance. I’ve had especially good luck with the adaptive pressure advance and highly recommend taking the time to calibrate it.
Nomad@infosec.pub 1 month ago
Try decreasing the speed in corners and increase pressure advance a bit. There is a tuning print you can use.
Natanox@discuss.tchncs.de 1 month ago
It’s not just in corners.
MrTolkinghoen@lemmy.zip 1 month ago
PA can impact more than just corners. It’s when the print head is changing speed/direction
kata1yst@sh.itjust.works 1 month ago
Extrusion width?